In this case, the viscosity of cellulose is usually too high. Some manufacturers use cellulose with viscosity of 200000 to make putty. Due to the high viscosity of putty, it appears thick when puttying, and the putty on the inner wall is general. The recommended dosage is 3 ~ 5kg and the viscosity is 80000 ~ 100000.

防水膩子很難打磨？

Waterproof putty is difficult to polish?

由于耐水膩子強度高，產品附著力大,膩子粉廠家，比不耐水膩子更難攪拌和刮擦。耐水膩子的強度也比不耐水膩子高，打磨會比較費力。

Due to the high strength of water-resistant putty and high product adhesion, putty powder manufacturers are more difficult to stir and scrape than water-resistant putty. The strength of water-resistant putty is also higher than that of non water-resistant putty, and grinding will be more laborious.

1、施工時盡量不要留下劃痕。如果有劃痕，可以用工具刮掉。

1. Try not to leave scratches during construction. If there are scratches, they can be scraped off with a tool.

2、膩子層90%干后再安排打磨，省力又不粘砂紙。

2. Polishing shall be arranged after 90% of the putty layer is dry, which saves labor and does not stick sandpaper.

3、拋光后應立即清除表面灰塵層,內外墻膩子粉，防止二次室內灰塵污染。

3. After polishing, the dust layer on the surface and putty powder on the inner and outer walls shall be removed immediately to prevent secondary indoor dust pollution.

4、手工打磨時，將砂紙（布）包在打磨墊上，用力推動打磨墊。不能只用一兩根手指按壓砂紙進行打磨，以免影響打磨的平整度。對于機械拋光，通常使用電動研磨機。砂紙夾在研磨機上，輕輕推在基層上。嚴禁用力按壓，以免電機過載損壞。

4. During manual grinding, wrap sandpaper (cloth) on the grinding pad and push the grinding pad hard. Do not use one or two fingers to press the sandpaper for grinding, so as not to affect the flatness of grinding. For mechanical polishing, an electric grinder is usually used. The sandpaper is clamped on the grinder and gently pushed on the base course. Do not press hard to avoid motor overload damage.

膩子粉刮的時候明顯很重。膩子粉是膩子粉主要選用纖維素。膩子粉可以保證施工時的和易性,內外墻膩子粉廠家，不會造成脫粉等問題。有直接關系。

The putty powder is obviously heavy when scraping. Putty powder is mainly cellulose. Putty powder can ensure the workability during construction. The manufacturer of putty powder for internal and external walls will not cause problems such as powder removal. Directly related.