(4) According to its use, it can be divided into external wall putty powder and internal wall putty powder.

　?、莅凑展δ苡挚梢苑譃榉浪佔臃?，柔性膩子粉，抗裂膩子粉等。

　　According to the function, it can be divided into waterproof putty powder, flexible putty powder, anti-cracking putty powder and so on.

　　注意事項：

　　Matters needing attention:

　?、倨胀佔臃蹜撚糜诓灰竽退膱龊稀Ｄ退佔臃蹜撚糜谝竽退?、高粘結強度的場所。

　　General putty powder should be used in situations where water resistance is not required. Water-resistant putty powder should be used in places requiring water resistance and high bonding strength.

　　②吸水性強的基層應先用清水潤濕或噴刷膠水進行封底處理后再刮耐水膩子粉。

　　(2) The base with strong water absorption should be wetted with clear water or sprayed glue to seal the bottom before scraping water-resistant putty powder.

　?、坌履ǖ乃鄩诒ｐB期后再刮膩子。

　　(3) The new cement wall should scrape putty after the maintenance period.

　?、苡娩摴伟寤蚰ǖ栋闯Ｒ幣?，刮涂次數不可過多，通常批刮兩次，第二次涂層需要在次涂層干透的情況下施工。

　　(4) Use steel scraper or spatula to scrape in batches according to the routine, scraping times can not be too many, usually scraping twice, the second coating needs to be constructed under the condition that the first coating is dry.

　?、菔┕囟?℃以上，固化溫度不低于0℃。施工溫度在0℃以上，膩子粉調成膏狀后應在4-5小時內使用，避免時間過長變質。

　　The construction temperature is above 5 C and the curing temperature is not less than 0 C. When the construction temperature is above 0 C, putty powder should be used within 4 - 5 hours after being adjusted into paste to avoid long deterioration.

　?、弈佔臃鄄荒芘c其他膩子再同一施工面使用，以免引起化學反應和色差。

　　Putty powder can not be used on the same construction surface as other putties in order to avoid chemical reaction and color difference.

　　⑦運輸方式可按照《非危險品》處理。保質期為12個月，應存放在陰涼干燥的地方。

　　The mode of transport may be handled in accordance with the "Non-Dangerous Goods". The shelf life is 12 months and should be stored in a cool and dry place.

　　批好膩子后我們可以通過眼睛觀看是否有無透底、反銹、反堿、氣泡，疙瘩等，用燈照看有無明顯氣泡、砂紙痕道、無透底反堿現象，還可以用指甲劃一下，墻皮的硬度如果沒有劃痕等方式檢測是否合格。

　　After the putty is approved, we can see through the eyes whether there are no bottom penetration, anti-rust, anti-alkali, bubbles, pimples and so on. We can use the lamp to see whether there are obvious bubbles, sand paper marks, no bottom penetration anti-alkali phenomenon. We can also use nails to scratch, if there is no scratch on the hardness of the wall, and other ways to detect whether it is qualified.

　　以上內容由濟南膩子粉廠家整理發布，更多相關信息可以點擊我們的官網進行咨詢：http://m.netjobs.cc/

　　The above content is organized and published by Jinan putty powder manufacturer. More relevant information can be consulted by clicking on our official website: http://m.netjobs.cc./