The equipment proportion and material selection of mortar indicate that the selection of agent will affect the use role in the future, poor mortar will lead to poor bonding effect, and serious will lead to the falling of external wall tiles soon, so it is necessary to choose high quality mortar for purchase, and do a good job of prevention and control of mortar bond.

　　1. 不要用作磚墻。砌筑前應先潤濕1 ~ 2d，使燒結普通磚及多孔磚含水率達到10% ~ 15%;灰砂磚、粉煤灰磚含水率達8% ~ 12%。

　　1. Do not use as a brick wall. Before masonry, the water content of sintered common brick and porous brick should be wetted for 1-2D, and the water content of lime sand brick and fly ash brick should be 10% - 15% and 8% - 12% respectively.

　　2. 在冬季施工期間，磚面也應適當潤濕后再砌筑在積極的溫度條件下。當磚不能在負溫下澆注時，應適當增加砂漿的稠度。9度抗震設防區，嚴冬不能燒磚砌筑，不能進行砌筑。

　　2. During winter construction, the brick surface shall also be properly wetted before masonry under positive temperature conditions. When the brick cannot be poured under negative temperature, the consistency of mortar shall be increased appropriately. In the seismic fortification area of degree 9, bricks cannot be fired or laid in severe winter.

　　3.采用料漿法敷設時，必須控制料漿長度，一般溫度不得超過750mm。施工期間溫度超過30℃時，不得超過500mm。

　　3. When the slurry method is used for laying, the slurry length must be controlled, and the general temperature shall not exceed 750mm. When the temperature exceeds 30 ℃ during construction, it shall not exceed 500mm.

　　迫擊炮

　　Mortar

　　4. 砌筑方法的改進。不適合采用砌筑灰漿或砌筑磚塊的方法。我們應該實行“三位一體砌磚法”，即用一鏟大磚、一磚、一鏟灰、一擠法砌磚。

　　4. Improvement of masonry method. It is not suitable to use the method of masonry mortar or brick. We should carry out the "Trinity bricklaying method", that is, one shovel of large bricks, one brick, one shovel of ash and one squeeze of bricks.

　　5. 提高砂漿和易性是保證砂漿豐滿度和粘結強度的關鍵。砂漿原材料的選擇是非常重要的。砂水泥應在保質期內，增稠劑纖維素醚和預拌砂漿的附著力可再?gòu)囊话闫髽I(yè)選用松膠粉。

　　5. Improving the workability of mortar is the key to ensure the fullness and bond strength of mortar. The selection of mortar raw materials is very important. The adhesive force of thickener cellulose ether and premixed mortar can be selected from general enterprises.

　　選擇什么樣的灰漿會決定以后的使用作用，現在生產灰漿的廠家越來越多，選擇正規的廠家，會避免很多不必要的麻煩。

　　Choose what kind of mortar will determine the future use. Now there are more and more manufacturers of mortar. Choosing a regular manufacturer will avoid many unnecessary troubles.

　　以上是濟南抹面砂漿廠家為大家介紹的相關內容，想要了解更多內容，歡迎訪問網站：http://m.netjobs.ccThe above is the relevant content introduced by Jinan plastering mortar manufacturer. To learn more, please visit the website: http://m.netjobs.cc